High Pressure One-hand Pumps

High Pressure One-hand Pumps with Gauge are used for hydraulic clamping tools and face milling gutters.

More and more face milling cutters and declamping tools are hydraulically clamped.
An implemented pressroom in the tool is put under pressure through grease or oil, so that the tool as example is pressed onto the shaft of the machine.

This kind of tension enables transferring high torque and therefore reaches an exact centrical tension.

Character features of ABNOX High Pressure One-hand Pump:

• Ergonomic plastic handle for comfortable and simple handling

• Controlled and accurate application, due to Check Valve, Air Bleed Valve and Pressure Release Valve

• Generates high clamping force without ancillary power

• Easy and clean disconnection of Nipple due to Pressure Release Valve and lubricant return flow to the cylinder

• The Pressure Gauge serves as control tool for clamping or precise controlled pressure build-up for tool chucks

• Model with cylinder 400/500 cm3 are suitable for the use of cartridges DIN 1284 and have a special cylinder design optimised for trouble-free application of cartridge

• No reversal of the cylinder piston seal (lip seal) for filling required

Important information:

• The temperature has a high influence on setting the pressure to the clamping unit and on the choice of the High Pressure One-hand Pump. If the temperature falls, pressure also drops, and vice versa. Differences in temperature of more than 30°C will most probably require a further setting of the pressure to the clamping unit. Regular controls have to be done.
• Only 400 g cartridges according to DIN standard 1284 with the following dimensions may be used for the 400/500 cm3 ABNOX cylinder: